VIN INSPECTION
Vehicle VIN plates match, engine compartment, door jambs and dash
VIN/FMVSS label on door jamb
Perform VIN status check, perform applicable recall or campaign repairs
UNIBODY INSPECTION
Carefully inspect unibody for signs of damage or prior repairs
MECHANICAL INSPECTION MINIMUM REPLACEMENT ITEMS
Engine oil and filter (with genuine Honda filter)
Air filter (if dirty or at service interval)
Brake fluid (if discolored or at service interval)
Floor mats (replace mats, unless current model)
Wiper blades (replace if needed)
Coolant (replace if discolored or at service interval with genuine Honda fluid)
Tires (minimum tread depth 5/32 across tread width)
Disc brake pads (if wear is greater than 50%)
Brake shoes (if wear is greater than 50%)
Antenna mast (if bent or sticking, if applicable)
Automatic transmission fluid (if discolored or at service interval)
Differential fluid (if discolored or at service interval, if equipped)
Rear differential fluid (VTM) (if discolored or at service interval, if equipped)
Minimum two master keys, one valet and two remotes (if equipped with OEM remotes)
Scheduled Maintenance - Nearest scheduled maintenance must be performed if within 3 months or 2500 miles of service interval or if no record of service exists
ROAD TEST
Starting/ Starter (cold/hot)
Idle vibration (cold/hot)
Engine noise (cold/hot & high/low speeds)
Acceleration (power)
Engine operating temperature
Driveability (smoothness)
AT shift quality/AT shift points
MT shifter operation
MT clutch (smoothness, effort, slippage)
Transmission/transaxle noise (cold/hot)
CV joint/drive axle noise (full lock turn)
Braking (noise, vibration, effort)
Parking brake operation
Steering effort (drifting right or left)
Steering wheel free play/steering wheel centered
Cruise control operation (Including resume)
Horn operation
Wind noise/squeaks/rattles
Speedometer/odometer operation
Heater/defroster operation
A/C cooling performance/vent outlet temperature
Tire or steering wheel vibration
Body/Suspension (Performance/Noise/Rough Road test)
UNDER HOOD—CHECK FOR UNACCEPTABLE AFTERMARKET MODIFICATIONS
Battery (condition, Fluid level, Load Test
Alternator (belt condition/tension, charging)
Water pump (noise / leaks)
Distributor (cap & rotor condition, shaft looseness)
Ignition system operation
Fuel system operation (connections/leakage)
Fuel filter (replace per maintenance schedule)
Radiator (leaks, road hazard damage)
Coolant recovery tank (condition, fluid level, sensor operation)
A/C condenser (corrosion, road hazard damage)
Cooling fan operation
Coolant (replace if discolored, insufficient protection)
Coolant hoses (check condition)
Power steering (fluid level, belt condition/tension)
AC compressor (proper cycling, belt condition/tension)
Heater valve adjustment
Engine Valve noise
Engine/Transmission mount condition
Engine condition (visual verification of oil change maintenance)
Timing belt condition (change per maintenance schedule)
Brake master cylinder and booster (operation/leaks)
UNDER VEHICLE—CHECK FOR UNACCEPTABLE AFTERMARKET MODIFICATIONS
Tires (OEM size, speed and load rating/ matching brand and type)
Tires (No road hazard damage/proper tire pressure)
Tires (Check for uneven wear or sidewall cracking)
Wheels/rims (Check for damage)
Valve stem condition
Wheel lug nuts (all present and properly torqued)
Spare tire (condition/pressure)
Engine (oil leaks, drain plug threads)
Transmission leaks
Coolant leaks
CV Joint/boots/drive-shaft/universal joint (cracks, leakage)
Brake pad thickness
Brake rotor thickness and surface
Brake caliper leakage
Hydraulic hose/line leakage and free movement
Suspension (springs proper ride height)
McPherson strut/shock absorber leakage
Bushing condition
Ball joint and tie rod end tightness
Power steering rack leakage
Entire exhaust system (condition, leaks, damage, noise, catalytic converter and converter shield)
EXTERIOR—CHECK FOR UNACCEPTABLE AFTERMARKET MODIFICATIONS
Headlights (high/low operation and headlight aim, cracks, chips, scratches, pitting)
Brake lights
Turn signal lights (operation, cracks, chips, scratches)
Parking lamps
Fog lamps (if applicable)
Running lights (if applicable)
License plate light
Tail lights (operation, cracks, chips, scratches, damage)
Back-up lamps
Emergency flasher
INTERIOR—CHECK FOR UNACCEPTABLE AFTERMARKET MODIFICATIONS
Water leaks (look for evidence of water intrusion)
Fuel gauge operation
Temperature gauge operation
All warning lights illuminated with ignition "ON"
Dash light operation
Windshield wiper/washer operation
Audio System - Radio/CD/Cassette, speaker operation (Audio steering wheel controls if equipped)
Navigation operation (if equipped)
Rear camera (MDX only if equipped)
OnStar operation (if equipped) (service not provided)
Clock functions
Steering wheel tilt/lock
Sunroof operation (if applicable)
Headliner condition
Cigarette lighter/power outlets (if equipped)
Alarm/theft system operation (check remote)
SRS air bags (exterior condition/check warning lamp self check)
Outside mirror operation (left and right)
Rear view mirror operation (day/night operation)
Window operation (noise, speed and full travel)
Door locks (check manual and or power operation and child safety function)
Seat belts (condition, proper latching and retraction operation)
Seat upholstery/leather condition (front & rear)
Power seat operation (if equipped)
Seat heaters (if equipped and check for proper operation)
Headrest movement
Rear defrost operation
Inside mirror/vanity light operation
Interior lights (switch/door operation, warning chimes)
Glove box/glove box light operation
Luggage compartment (jack and tool present)
Truck lid release/trunk lid light operation
Fuel door release
Hood release operation
APPEARANCE INSPECTION POINTS:
EXTERIOR - Check for Unacceptable Aftermarket Modifications
Underhood (clean engine compartment)
Front bumper (facia, guards, finish)
Grille (headlights, other lights, trim, emblems)
Hood (emblems & finish)
LF fender (finish, trim)
LF door (finish, trim)
LR door (finish, trim)
LR fender (finish, trim)
Truck lid (finish, trim)
Rear bumper (facia, guards, trim)
RR fender (finish, trim)
RR door (finish, trim)
RF door (finish, trim)
RF fender (finish trim)
Roof (finish, trim)
Windshield/glass (cracks, chips, scratches, pitting)
Check for dent, dings & scratches on all body panels and bumpers
APPEARANCE INSPECTION POINTS:
INTERIOR - Check for Unacceptable Aftermarket Modifications
Dash and instrument panels
Console/center arm rest/cup holders
Front doors (controls, trim condition)
Rear doors/quarter Trim (controls, trim condition)
Luggage compartment (mat/trim/carpet condition)